Digiplex EVO641R Manual de instalación descargar pdf (Pagina 58)

58 - Modules Programming Guide

NOTE 1: 000 = Occurs in all partitions enabled in the system (refer to the appropriate control panel Programming Guide).

001 = Partition 1 003 = Partition 3 005 = Partition 5 (EVO192 only)007 = Partition 7 (EVO192 only)

002 = Partition 2 004 = Partition 4 006 = Partition 6 (EVO192 only)008 = Partition 8 (EVO192 only)

255 = Occurs in at least one partition enabled in the system.

NOTE 2: This TLM trouble event can only be used with EVO641R control panels that have two dialers.

NOTE 3: This TLM trouble event can only be used with EVO48 control panels or EVO641R control panels that have one dialer.

NOTE 4: This event cannot be used for a module’s PGM programming.

: If a Keyswitch Input is used, the input must be defined as “Generates a Utility Key Event on Open” or “Generates a Utility Key Event on Open

and Close”. If a remote control is used, the remote control button must be defined as a Utility Key button.

**:

Actions that Activate a Utility Key Event

066

Status 3

See Note 1

on page 58

Intellizone Delay Engaged (see

Note 4 on page 58)

000 000

Fire Delay Engaged 001 001

Auto Arm 002 002

Arming with Voice Module (set until

Exit Delay finishes)

003 003

Tamper 004 004

Zone Low Battery 005 005

Fire Loop Trouble 006 006

Zone Supervision Trouble 007 007

067

Future Use

Future Use Future Use Future Use Future Use

070

Clock

N/A Hour Minutes

Event

Group

Event Feature Group Feature Start # End #

1 2 ... 53 54 55 56 57 58 59 60

Sin comentarios

Digiplex EVO641R Manual de instalación Pagina 58