Digiplex EVO641R Manual de instalación descargar pdf (Pagina 48)

48 - Modules Programming Guide

Access Control Module (DGP-ACM12)

Splice all

cables here

Connecting Access Control Devices to the DGP2-ACM12

Caution:

Disconnect

battery before

replacing fuse.

Digiplex/ Digiplex

EVO Control Panel

Rechargeable

Battery

YUASA model

#NP7-12 UL/ULC

12Vdc/4Ah

When using the on-board power supply, the

12Vdc power supply output will automatically

shut down if the current exceeds 1.1A (see

Inset 1).

Reader

Cable

Routing Cable

Do not use twisted pairs or

twisted cables for the routing

cable.

CR-R880-BL Indoor/Outdoor

Proximity Reader with 10cm

(4in) Read Range

Also supports the CR-R885-BL.

If a routing cable is required to connect the reader to the

module, the routing cable must be shielded. Do not

connect the shield wires together at the reader cable

splice. With the shield wire already terminated at the

reader, simply terminate the shield at the module. Do not

connect the shield to the black wire at the reader cable

splice.

The external negative trigger can be connected to either the PGM output of the control

panel or module or to a push button. Once connected, either the programmed event or

the pressing of the push button will send a signal to the external negative trigger and

open the door lock.

To PGM output

When connecting the diode to the door lock,

be sure to connect the cathode of the diode to

the positive (+) voltage and the anode to the

negative (-) voltage.

Door Lock

See Inset 1

Door Contact

Must be

connected to CT

terminal**

Paradoor 460

Request to Exit device must be connected to REX terminal***

* =

** =

*** =

Combus

12Vdc

AWG #14

single

conductor solid

copper wire

Press to

toggle the

AUX output

DGP-ACM12

CONV4USB

Use one

transformer to

power multiple

modules

From Transformer

Connect to

another module

compatible with

transformer

sharing

External Negative Trigger

External Tamper

Switch (N.C.)

Ground clamp

Cold water pipe

grounding

Follows control panel’s EOL definition.

If the door contact is not used, install a

jumper or a 1kW resistor across the AUX-

and CT terminals depending on the

control panel’s EOL definition.

If the Request for Exit device is

not used, place a jumper

across the AUX- and REX

terminals.

Inset 1

Connecting the Anti-

Tamper Switch

Connecting the External Negative Trigger

Transformer Sharing

Connecting for Firmware Upgrade

Connecting a 7-Wire Routing Cable Cable

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Comentarios a estos manuales

Sin comentarios

Digiplex EVO641R Manual de instalación Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digiplex EVO641R