Digiplex EVO641R Manual de instalación descargar pdf (Pagina 43)

Modules Programming Guide - 43

Motion Detector Modules (DGP2-50/60/70)

PCB Height Adjustment

DGP2-50/60/70 is designed for optimal performance at

a height of 2.1m (7ft), but can be installed lower or

higher. After you have installed the motion detector,

ensure that the PCB Height Markings match the

installation height. The installation height is measured

from the ground to the base of the motion detector's

cover.

For example, if the motion detector is installed at a

height of 2.1m (7ft), the PCB should then be adjusted

to 2.1m (7ft). To adjust the PCB height, remove the

PCB screw and align the PCB Height Tab with the

desired height marking on the PCB.

Addressable High-Security

Motion Detectors

(DGP2-70)

Addressable Digital

Motion Detectors

(DGP2-50/60)

1) LENS

2) BEZEL PIN

3) SENSOR (S)

4) ANTI-TAMPER SWITCH

5) PCB SCREWS

6) METAL SHIELD

7) DETECT/ALARM LED (red)

Flashing: Unable to communicate with the control

panel.

8) PROTECT INDICATOR LED (green)

Locate: If activated, the LED will flash until the

Anti-Tamper Switch is pressed or the detector’s

serial number is entered

9) PCB HEIGHT TAB

To Digiplex

EVO control

panel.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Sin comentarios

Digiplex EVO641R Manual de instalación Pagina 43