Digiplex EVO641R Manual de instalación descargar pdf (Pagina 20)

20 - Modules Programming Guide

MG-RTX3 V1.1

Magellan Wireless Expansion Module

When using on an EVO96 version 1.52 or higher without an EVO641, enable option [1] in section [3029].

U = Default setting

Section [001]

Options OFF ON

[1]

Low battery supervision

Disabled

Enabled

[2]

Check-in supervision

U Disabled N

Enabled

[3]

Check-in supervision time interval

U 24 hours N

80 minutes

[4]

RF Jamming supervision

Disabled

U Enabled

[5]

On-board module tamper

U Disabled N

Enabled

[6] & [7]

Future use

NN/A NN/A

[8]

Transmitter tamper signal

U Ignored N

Reported

Section

[030] View a transmitter’s unknown 6-digit serial number

Sections

[101] to [132] Assign the transmitters to the MG-RTX3 by entering their 6 digits serial numbers in the appropriate section or by

pressing and releasing the transmitter’s tamper switch.

[101] = Transmitter/Input 1, [132] = Transmitter/Input 32

To delete the assigned transmitters, enter 000000 as a serial number

Sections

Transmitter Info

[601] to [632]

View the transmitters’ signal strength (3 or less is too weak and the transmitter should be moved, 4 to 10 is acceptable.)

[601] is Transmitter/Input 1, [632] is Transmitter/Input 32)

[701] to [732]

View the current battery life of the transmitters (Number of weeks the batteries have been in the transmitter.) [701] is

Transmitter/Input 1, [732] is Transmitter/Input 32)

[801] to [832]

View the previous battery life of the transmitters (Number of weeks the previous batteries were in the transmitter.) [801]

is Transmitter/Input 1, [832] is Transmitter/Input 32)

[671] to [678]

Two-Way PGM

View Two-Way PGMs’ signal strength. (3 or less is too weak and the transmitter should be moved, 4 to 10 is

acceptable.)

[901] to [908]

Assign or delete Two-Way PGM (Enter the PGM’s serial number or press and release the transmitter’s tamper switch to

assign it, or enter 000000 to delete it. Section [901] = PGM 1, section [908] = PGM 8. For [901] to [904], entering

000000 will assign it to the on-board PGM.)

[910] to [989] Program the Two-Way PGM. (SeeTable 4 on page 21)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Comentarios a estos manuales

Sin comentarios

Digiplex EVO641R Manual de instalación Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digiplex EVO641R