Digiplex DGP2-641R Manual de instalación descargar pdf (Pagina 36)

32 Reference & Installation Manual

Forced Door: If a protected door was opened without an “Access

Granted” or “Request for Exit” signal, a silent or audible

Access Alarm can be triggered. If the Access Alarm is

programmed to be audible, the reader assigned to the

door can beep. This event is logged in the Event Buffer

and cannot be reported to a Monitoring Station unless the

door is also assigned to a zone. If the door is assigned to a

zone, the Forced Door can also trigger a Burglar Alarm in

the system.

Holidays: Days programmed in the control panel that are not

considered normal work days, such as legal, religious, and

feast days.

Pre-Alarm: A beep tone warning that an Access Alarm will be

generated if a protected door is not closed within a

specified period.

Reader: An Access Control device normally located near a

protected door that serves to relay the information from an

Access Control card presented to it to the control panel.

The DGP2-641R has a reader built in and does not require

an external reader.

Request for Exit: When a REX device (Paradoor 460) installed above an

Access Control door within a protected area detects

movement, it sends a signal to the control panel to permit

a user to leave the protected area. This signal is a

“Request for Exit” event that is logged in the Event Buffer

and cannot be reported to a Monitoring Station.

Schedule: Schedules determine the hours, days, and holidays that

users are permitted access.

Valid Card: An Access Control card presented to the keypad during its

assigned Schedule and within its assigned Access Level.

DGP2641R_ei00.fm Page 32 Thursday, July 22, 2004 4:16 PM

1 2 ... 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Digiplex DGP2-641R Manual de instalación Pagina 36