Digiplex DGP2-641R Manual de instalación descargar pdf (Pagina 13)

DGP2-641R LCD Keypad Module 9n

3.2 Programming Methods

The following methods can be used when programming the keypad:

3.2.1 Feature Select Programming

Some sections are programmed by enabling or disabling

options. Within the sections, numbers from [1] to [8] represent a

specific keypad option. Press the key corresponding to the

desired option and the digit will appear in the display. This

means the option is enabled. Press the key again to remove the

digit from the display thereby disabling the option. Press

[

ENTER] when options are set.

3.2.2 Decimal Programming

Some sections require that a decimal value be entered. In this

method, any digit from 000 to 255 can be entered.

3.3 Module Broadcast

The control panel’s Module Broadcast feature can be used to copy the

contents of one keypad to one or many other keypads.

1. From Normal Mode press and hold the [0] key.

2. Enter [

INSTALLER CODE] (default: 000000).

3. Enter section [954] (DGP-848) / [4004] (DGP-NE96).

4. Enter the [

SERIAL #] of the source keypad. The source is the

programmed keypad whose data you want to copy to other

keypads.

5. Enter the [

SERIAL #] of the destination keypads. The destination is

the keypad(s) you want to program with the source’s data. If you

want to program more than one keypad with the source’s data,

enter the serial numbers of the keypads one at a time.

6. Once you have entered the serial numbers of the keypads you want

to program, press the [

ACC] key.

DGP2641R_ei00.fm Page 9 Thursday, July 22, 2004 4:16 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sin comentarios

Digiplex DGP2-641R Manual de instalación Pagina 13