Digiplex DGP2-641BL Manual de instalación descargar pdf (Pagina 38)

38 - Digiplex Modules Programming Guide

Access Control Module (DGP2-ACM1P)

If you are not using the DGP2-ACM1P’s on-board

power supply, connect the “red” of the combus to

the “aux+” in order to power the module. Please

note that in such cases, the DGP2-ACM1P is

either the DGP2-ACM1P’s auxiliary output (aux) or

to an external power supply. Also, if the on-board

power supply is not being used, you must disable

DGP2-ACM1P’s AC and Battery Supervision

feature (refer to page 26).

Splice all

cables here

See Inset 1

Connecting Access Control Devices to the DGP2-ACM1P

Caution:

Disconnect

battery before

replacing fuse.

Digiplex

Control

Panel

Rechargeable

Battery

YUASA model

#NP7-12 UL/ULC

12Vdc/4Ah

12Vdc Power Supply

Output

To power REX, door

contact and door lock

(see Inset 1)

When using the on-

board power supply,

the 12Vdc power

supply output will

automatically shut

down if the current

exceeds 1.1A (see

Inset 1).

Reader

Cable

Routing Cable

Do not use twisted pairs

or twisted cables for the

routing cable.

PosiProx

CR-R880-A

Also supports

the PosiPIN

PIN &

Proximity

Reader (CR-

R885-BL)

If a routing cable is required to connect the reader to the

module, the routing cable must be shielded. Do not connect

the shield wires together at the reader cable splice. With the

shield wire already terminated at the reader, simply terminate

the shield at the module. Do not connect the shield to the

black wire at the reader cable splice.

Connecting a Routing Cable

Connecting the External Negative Trigger

The external negative trigger can be connected to either the PGM output

of the control panel or module or to a push button. Once connected, either

the programmed event or the pressing of the push button will send a

signal to the external negative trigger and open the door lock.

PGM output from

control panel or

another module

Push Button

When connecting the diode to the door

lock, be sure to connect the cathode of

the diode to the positive (+) voltage and

the anode to the negative (-) voltage.

Door Lock

See Inset 1.

Door Contact

Must be connected to

CT terminal**

Paradoor 460

Request to Exit device must be connected to REX terminal***

Follows control panel’s EOL

definition.

If the door contact is not used,

install a jumper or a 1kW resistor

across the AUX- and CT

terminals depending on the

control panel’s EOL definition.

If the Request for Exit device is

not used, place a jumper across

the AUX- and REX terminals.

* =

** =

*** =

For information on the Access Control Module’s LEDs,

refer to Module LED Indications on page 30.

Refer to Module Connection Overview on page 30 for

information on how to connect the Access Control

Module’s PGM output (Figure 3). Before commencing

with the connections, please read the General Warnings

listed on page 30.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Comentarios a estos manuales

Sin comentarios

Digiplex DGP2-641BL Manual de instalación Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digiplex DGP2-641BL