Digiplex DGP-641 Manual de usuario descargar pdf (Pagina 38)

36 User’s Manual

Door Left Open: Each Access Control door is programmed with a

period of time it is allowed to remain open. Once

the door has been open past this time limit, an

Access Alarm will be triggered.

Event Record The user-initiated actions, alarms, and troubles that

Display: occur in the system are saved in the control panel’s

memory. The Access Control events, however, can

only be viewed through an Access Control Keypad

(DGP-641ACC). See the Digiplex LCD Keypad

User’s Manual for details.

Forced Door: If a protected door was opened without an “Access

Granted” or “Request for Exit” signal a silent or

audible Access Alarm can be triggered. If the Access

Alarm is programmed to be audible, the reader

assigned to the door can beep. This event is logged in

the Event Record Display, but can only be seen

through an Access Control keypad (DGP-641ACC)

and cannot be reported to a Monitoring Station unless

the door is also assigned to a zone. If the door is

assigned to a zone, the Forced Door can also trigger a

Burglar Alarm in the Digiplex Alarm System.

Holidays: Days programmed in the Schedule that are not

considered normal work days, such as legal,

religious, and feast days.

Pre-Alarm: A beep tone warning that an Access Alarm will be

generated if a protected door is not closed within a

specified period.

Reader: An Access Control device (Posiprox CR-R880)

normally located near a protected door that sends

a signal to unlock the door to permit a user to enter

ACCKEU00.fm Page 36 Wednesday, November 24, 1999 11:05 AM

1 2 ... 33 34 35 36 37 38 39 40 41

Sin comentarios

Digiplex DGP-641 Manual de usuario Pagina 38